My Cart
Call 1-616-606-5045
Email: info@QSALTS.com

# ERCKE - Dodge-Chrysler-Jeep External Voltage Regulator Kit, Chrysler Dodge Jeep, Standard Duty non-ajustable Voltage Regulator, Economy version

SKU
3309
$44.95
CLICK IMAGE FOR DETAILS

 

External Voltage Regulatorkit for 1988 & up Chrysler Corporation Vehicles

#ERCKE

Since 1987 for Dodge and Chrysler vehicles and since 1991 for Jeep Family vehicles have alternators that are controlled by the Alternator Voltage Regulator Control Module inside the vehicle computer.

Engine Control Unit (Computer).

This is often called the ECC, ECM, EEC, or PCM. Often the alternator voltage regulator, or field control module, in the ECU will fail, leaving you with a dead charging system where your alternator doesn't work, but your engine runs just fine. Before our external voltage regulator conversion kit, the entire ECU needed to be replaced at a cost of between $150 and $1800.

In order to avoid costly computer replacement and get your alternator working, you can simply bypass the internal Alternator Voltage Regulator Control Module using our simple External Voltage Regulator Conversion Kit.

Note: This kit will not put out the check engine light, USE KIT #ERCKFRM which comes with a better upgraded voltage regulator  plus the field replacement module to put out the light.

Kit Contents:

Light Duty # C8312 non-Adjustable Voltage Regulator

Wiring harness to Alternator in split tubing with molded Plug to Regulator

14 Gauge Grounding wire from Regulator to Alternator

#10 Insulated Ring terminals 14/16

1/4"  Insulated Ring terminal 14/16

Insulated Butt Splice Connectors

Flat Blade Connectors

Hex Head Regulator Mounting Screws

Regulator Grounding Screw

Zip Ties

Instruction Sheet (English) other language downloaded in PDF format, message me

How to test your alternator on the vehicle:

To check to see if your alternator is working, unplug or remove the two field wires from the back of the alternator. Then ground one of the field terminals on the alternator and jumper the other field terminal to the positive battery post on the back of the alternator. It does not matter which terminal is grounded and which one get positive power. When you connect the ground and positive wires to the field terminals you will get a small spark, this is normal. This is by-passing the voltage control and will cause your alternator to run full blast, if it is working. Put a multi-meter on your battery and run your engine on high idle, do not allow your alternator to charge the battery much over 16 volts. If you find that your alternator is charging when you do this procedure, but does not charge when you connect it back to the computer, this kit will get your alternator working and charging at the proper voltage. The voltage regulator is preset at 14.5 volts. If you want to adjust the voltage regulator you use the screw on the back, but be sure the metal case of the voltage regulator is grounded while you adjust it.


Ref: QSERCK , ERCK